How to glue a broken cigarette

Content

Method 2 of 2: Use a rolling tissue paper
Additional articles

1 Rip the cigarette completely into two halves. Sometimes cigarettes don't break completely. To use this method, you need to split the cigarette into two separate parts. This step is necessary because you will need to insert one part of the cigarette into the other.

2 First take the piece of filter cigarette. Look at the line where the tobacco filling of the cigarette ends. Remove any tobacco and paper scraps that remain in the cigarette beyond this line. Now this piece of cigarette should be just a filter and a piece of paper tube. Set it aside temporarily.

3 Take the other half of the cigarette. Pay attention to the dangling end and remove any loose tobacco from that side. Then, gently roll this end of the cigarette piece between your fingers, as if you were wrapping the candy back in a wrapper so that no more tobacco spills out of the cigarette. Do not twist the end too much, otherwise air will not flow through it.

4 Insert the twisted end of one piece of cigarette into the hollow paper tube of the other piece. With a gentle twisting motion, push one part of the cigarette into the other until they join together. Be extremely careful, otherwise the cigarette may break into more parts again.

If you are unable to connect the two parts of the cigarette together, do not try to do it by force.
If you are having difficulty connecting two cigarette debris, you can use tissue paper to repair the broken cigarette. Check out the second method in this article.

5 Light the cigarette as usual and smoke it. Smoking a reconstituted cigarette should go without any problems.

Method 2 of 2: Use a rolling tissue paper

1 Take a piece of rolling tissue paper and place it on a flat surface. Working on a flat surface (table or countertop) will make it easier for you to wrap the cigarette with tissue paper. Tissue paper can be purchased at specialty tobacco stores or hardware stores.
2 Place the broken cigarette in the center of the tissue paper. When placing two separate parts of a cigarette on the paper, align them together so that it is not clearly visible that the cigarette is broken. In this case, you will be able to wrap the cigarette in tissue paper and smoke it without any problems.
3 Wrap the cigarette with tissue paper. Wrap the cigarette tightly with tissue paper to securely hold the two parts of the cigarette together. Start by wrapping one side of the tissue paper over the cigarette to cover the broken area.
- Then roll the tissue paper tightly over the cigarette. Do this by pressing the cigarette firmly against the table so that the tissue paper wraps around it tightly enough.
- When you get to the opposite side of the piece of tissue paper, lift the cigarette off the table and lick that edge of the paper. Then attach it to the cigarette and press down so that it stays in place.
4 Use only the adhesive part of the roll of cigarette paper. To repair a broken cigarette, if you wish, you can also use only the adhesive part of a piece of tissue paper. This method gives almost the same result as applying a whole sheet of tissue paper. Some people just prefer to have less paper on their cigarettes. It is for such cases that this method is suitable.
- Align the two pieces of the broken cigarette on the cut adhesive strip of tissue paper. Wrap the cigarette in paper and lick it for a final fix.
5 Smoke a cigarette as usual. The tissue paper should restore the broken cigarette to its original state. There should be no problems in using such a cigarette.