How to put on a wig

Video: The ULTIMATE MELT From START TO FINISH | Frontal Wig Install For BEGINNERS | Step By Step

Content

Method 2 of 2: Put on the wig
What do you need

1 Choose a specific type of wig. There are three types: full patch, partial patch, and no patch. There are also three types of material that wigs are made from: human hair, horse hair, and synthetic hair. All types of wigs have their pros and cons, so choose the wig that's right for you.

Wigs with a full patch on the bottom have a mesh frame to which the hair is tightly sewn. This makes the parting on the wig look natural. These wigs are usually made from human or horse hair and are easier to style because the parting can be done anywhere. In addition, such wigs are more pleasant to walk in because they breathe. The downside is that these wigs cost much more than all the others. In addition, they are easier to damage because they are made of a fragile material.
Partial patch wigs only have a mesh on the front. Hair looks natural on the forehead, but more durable materials are used on the main part of the head. These wigs are made from different materials and are cheaper than full patch wigs. Disadvantages include a lack of natural look and hair styling problems.
Wigs without patch are made using nylon mesh. They are made from any material, they are more durable and less expensive. However, these wigs do not look as realistic as others and are difficult to part or style.

2 Prepare your hair. You will have to style your hair carefully so that there are no protrusions and irregularities on the head. It doesn't matter how long your hair is, it is important to remove the parting so that it is not visible under the wig.

If you have long hair, you can split it in two, twist and criss-cross at the back of your head. Secure them with invisible top and bottom.
If you have long and thick hair, you can twist up small strands and pin them all over your head. Take a strand 2.5 cm wide, twist it around your finger. Fold the strand into a ring and lay on the back of the head. When all hair has been styled in this way, secure it with two invisible hairpins in a crisscross pattern. This will create a flat surface on which the wig will sit very well.
If you have short hair, just comb through it and remove the parting. You can wear a hair band to remove the parting.

3 Prepare your skin. Rub the skin along the hairline with cotton wool soaked in an alcohol-based solution.This will remove excess grease and dirt, which will help the glue or tape adhere better. Then apply the protectant to the skin around the hair. It comes in the form of a spray, gel or cream. This will protect delicate skin from irritation and micro-injury from glue or adhesive tape.

Even if you don't have hair and skipped the previous steps, you still need to prepare your skin.

4 Put on your hat. You can wear either a mesh or a flesh-colored nylon hat. In the mesh, the leather will breathe better, but the nylon cap will not differ in color from the leather. Pull the beanie on, smooth it over your head so that all your hair is under it. Secure it with invisible along the edges.

The cap should be worn on both short and long hair. If you don't have hair, you don't have to. The cap prevents the wig from slipping off, but it may not smooth the scalp.

5 Apply glue or tape. If you have glue, dip a makeup brush in it and apply a thin layer along the hairline. Let the glue dry - it will take a few minutes. When the glue hardens, it will become denser and tighter. If you have duct tape, apply double-sided tape to the skin around the hairline and press it against the skin. The tape does not need to dry.

To prevent the wig and cap from sliding off, apply glue or some tape to the edge of the cap. This will help hold the wig and cap in place, which will help the whole structure to hold better.
You can combine tape and glue. Do as you see fit.
There is no need to apply glue or tape around the entire perimeter, but it is very important to secure the wig to the forehead and temples. If this is not done, the wig will not fit naturally. You can reinforce other areas as you like.

Method 2 of 2: Put on the wig

1 Prepare your wig. Tie up all your hair in a ponytail before putting on your wig so that it doesn't come into contact with the glue. If the wig is short, pin up your longest hair.
- If you have a full patch wig, trim it so that the bottom edge is along the hairline. Don't cut too much and try not to damage the wig. Leave a small margin so the wig can be glued neatly.
- Don't worry about styling at this stage. When you put on the wig, all the hair will get tangled. You can comb and style them later.
2 Place the wig over your head. Press the wig down the middle with your finger, pull it gently over your head and spread over the head. Don't let the wig touch the glue as it is too early to fix it now.
- Do not bend over or pull the wig underneath. This will cause the wig to slip off-center and cause hair to stick to the glue.
- If this is your first time putting on a wig, start beforehand. It may not work out right away.
3 Secure the wig. Now you will need to attach the wig to the head. After placing it on your head, start pressing it around the edges with a fine comb. If you have a full patch wig, make sure the wig fits snugly around your head in all places and looks natural. After securing the front of the wig, let it sit for 15 minutes to allow the glue to dry. Then do the same for the back. Wait 15 minutes again and move on to styling.
- You can additionally secure the wig with invisibility. Thread the bobby pins through the outside of the wig, grabbing the cap and hair under the wig. Make sure the bobby pins are not visible.
- When the wig is in place, check for any glue residue on the skin. If left, rub these areas with a cotton pad moistened with alcohol.
- If you can't place the wig correctly the first time, rub the glue with a cotton swab dipped in alcohol solution, move the wig and do it all over again.
4 Style your hair and style it. Once the wig is in place, you can style your hair the way you want. You can get creative or pick something fun. The hair of the wig is braided, twisted or decorated with bobby pins.If you have a synthetic wig, do not heat your hair or it will melt.
- Before putting on a wig, you can cut it. This will make it look more natural and right for you.
- Remember that less is better. Whatever material your wig is made from, don't use too much styling products as they will leave marks on your hair.