Content

• Steps
• Advice

Babies do not need to bathe as often as babies for months or babies. The baby's skin dries out very quickly and if the baby's umbilical cord is not falling off, do not bathe the baby with anything except a sponge. When you bathe your baby, you need to take extra care to avoid accidents.

Steps

Part 1 of 3: Wipe yourself with a Sponge

1. 

   Wipe yourself with a sponge for the first three weeks. Your baby's umbilical cord will not fall out for about the first three weeks. The American Academy of Pediatrics recommends waiting until the umbilical cord falls into full contact with water. During this time, use only a sponge for your baby.
   • You do not need to bathe your baby every day for the first week after birth. In fact, too much bathing will harm your baby's skin. The new face, neck, and diaper areas are the ones that really need cleaning, and it's fine to use pads when your baby burps and diapers clean. No need to bathe your baby more than a few times a week.
   • Consult your pediatrician if your baby's umbilical cord has not fallen out after three weeks. This could be a sign of a larger problem or maybe just intervention to remove the umbilical cord.

2. 

   
   
   Prepare necessary supplies. You will need to have a lot of things ready so you can use them right away with a sponge. Make sure to remove all the necessary items before starting the cleaning process for your baby.
   • Find a warm, flat place. Should shower in kitchen or bathroom shelf. If the room is warm enough, then you can use the blanket on the floor as well.
   • You need to prepare a soft towel or mattress for your baby to lie down during the wiping process.
   • An extra sink or shallow plastic tub is required to hold the bath water.
   • Prepare extra towels, cotton pads, baby soap, wet paper, and clean diapers.

3. 

   
   
   Wipe baby. Once you have prepared all the necessary supplies, you can start wiping your baby.
   • Always hold the baby with one hand. Infants cannot control their movements, so you need to use one hand to keep the baby from injuring himself when he moves.
   • First, undress the baby and cover the baby with a towel. Place your baby on his back on a blanket or large towel.
   • Starting from the face. Wet a towel and wring it dry. Don't use soap in this step, as you can't let soap get in your baby's eyes. Gently wipe down the baby's face. Use a damp cotton pad or clean towel to gently wipe the baby's eyelids to wipe away any rust. Moving from the inside out.
   • Can you use water when cleaning the rest? However, if your baby is dirty or has an odor, use a baby safe moisturizing soap. Need to clean the crevices on the arms, ears as well as between the hands and feet.
   • Leave only the parts you are cleaning for your baby. You need to make sure your baby is kept warm.
   advertisement

Part 2 of 3: Bathing Your Baby in the Tub or Tub

1. 

   
   
   Choose a tub or bath for your baby. When your baby's umbilical cord has fallen off, you can bathe your baby in a tub or bath. You need to choose a pot that is safe for babies.
   • You can choose to buy sturdy, dedicated plastic baths for your baby at most baby stores or online. They also sell inflatable tubs that fit neatly in a bathtub or sink shelf.
   • As long as you place the tub or sink with a non-slip rubber pad, both are good choices when it comes to bathing your baby.
   • Fill a pot about 5 to 8 cm high with warm water. One hand must always hold the baby.

2. 

   Find a way to keep your baby firmly in the pot. Make sure your baby is safe in the tub. Keep your baby comfortable and don't move too much.
   • Always keep your baby safe, but don't upset him.
   • Use your arm to support the baby's head and upper body, while the other hand will bathe your baby. You can put your arm around the baby's back. When you start to clean your baby's back and buttocks, turn your baby around so he leans against your arm.
   • You can also buy baby shower chairs at baby stores or online. However, even if you use a shower chair, you should always hold your baby with your hand.

3. 

   Bathe your baby. Each feeding should not exceed 10 or 15 minutes.
   • Before placing your baby in the tub, take off his or her clothes from the top down to the diaper. Wipe your baby's face and eyes as if you were wiping your baby's body with a sponge, using a damp, soap-free cloth and a damp cotton pad to clean the eyelids.
   • When finished, remove the baby's diaper. If the diaper contains feces, wash your baby's anal and genitals before placing him in the sink. When you put your baby down, put his or her feet down first.
   • You can use your hands, sponge or a damp washcloth to gently clean your baby. You can also use baby safe soaps. If your baby's skin is dry, use a moisturizing soap.
   • You can use your hand to gently rack the baby with water while bathing to keep the baby warm.
   • No need to wash your baby's hair. However, if your baby's hair is dirty, or if the baby's scalp has a common phenomenon called buffalo shit, that is, the baby's scalp appears scaly patches, then you should wash your baby's hair. Gently rub the shampoo on your baby's scalp. Gently rub hair with a towel or rinse under running water. Always pay attention to the baby's forehead so that the shampoo does not get in his eyes.
   • When you are finished covering your baby, lift your baby out of the tub and quickly wrap the baby in a towel. Gently dry your body and put on clean clothes for your baby.
   advertisement

Part 3 of 3: Learn More Safety Instructions

1. 

   Check the water temperature. Water temperature is very important to your baby's safety. Make sure you know what the water temperature is before it is safe for your baby and makes your baby feel comfortable.
   • Best to pour cold water first then add hot water. Mix the water evenly so that parts of the water are neither cold nor hot.
   • It is best to invest in a thermometer to ensure the water temperature is at a safe level for your baby. Ideal temperature should be around 36.6 ° C. This is about normal body temperature. If you don't have a thermometer, check the warmth of the water with your elbow.
   • If your baby is able to reach the tap while bathing, prevent baby from touching it. As your baby gets older, he or she will have enough strength to turn on the faucet and may scare him.

2. 

   Find the right soap and conditioner. Because soap isn't always needed when bathing your baby, but if you choose to use soap, make sure it is safe for your baby.
   • Never use scented or foaming soaps. These soaps can dry out the skin and be uncomfortable for your baby.
   • Usually just using water is not enough. If you feel you need to use more soap, choose a mild, moisturizing soap specifically designed for your baby that won't dry out your baby's skin.
   • Usually, you shouldn't use extra moisturizing oil on your baby after bathing. Just dry the gaps in the baby's skin to avoid redness. If you still decide to add a moisturizer, choose a hypoallergenic one in case your baby is allergic to ingredients you don't know yet.

3. 

   Never leave your baby in the tub. Even if you only leave the room for a few seconds, it can be dangerous to leave your baby in the bath.
   • Always have all necessary supplies ready to bathe your baby before starting to put in water, you will not have to leave to pick up more.
   • If you really have to get out of the room, let your baby go out of the tub first. Babies can drown with just 3cm of water. Leaving a baby alone, even for a moment, is extremely harmful.
   • If you bathe your baby in a high place like the bathroom sink, he or she can fall and hurt easily.
   advertisement

Advice

• Be prepared because you will be a little confused in the first baths. This is a new activity for your baby, and your baby may cry or curl.
• Talk to your doctor or pediatrician if you notice unusual redness or skin abnormalities while bathing your baby.