Content

• What you need
• Advice
• Warning

• Wear rubber gloves when gluing and gluing. This will prevent the oil from being rubbed on the glass by your hands, while also protecting you from toxins and excess glue.
• Hard oily stains can be scrubbed off with a wool pad.

Spread the glue along the edge of a piece of glass. You only need a small amount, but make sure the entire broken glass edge is covered with glue. You just need to stick the glue on a piece of glass.

Press the two glasses together. Make sure the edge of the broken glass fits together and let it sit for at least 1 minute.

Scrape off excess glue with a razor. Test on glass before glue dries. Excess glue may bulge through the joint and begin to dry. Carefully scrape off excess glue with a razor and wipe the surrounding area.

• Both the UV glue and the silicon glue will be transparent when completely dry, so cracks will be pretty hard to see.

advertisement

Method 2 of 2: Decorative glass

1. 

   Prepare materials. A few simple steps will speed up the decoration process and make sure the glass is sticking.
   • Wash the glass well with soap and water.
   • Dry the glass with a paper towel.
   • Pour some glue into a plastic cup. This will make it easier to apply the adhesive with the brush, while also allowing the adhesive to dry slightly for the correct adhesion.

2. 

   
   
   Spread a thin layer of glue on the object. Spread it anywhere you want to decorate. Wipe off any excess glue and wait for it to dry.
   • The time it takes for the glue to dry is quite different depending on the type of glue you use. In most cases 5-10 minutes is sufficient.

3. 

   Apply a second layer of glue to a small area. When the first layer just dries, apply a little more glue to make the decorations wet and slightly sticky, preventing the trimming from slip.
   • Wait about 5-10 minutes for the glue to take effect.

4. 

   
   
   Stick the trinket to the spot where the glue was applied. If they slip, wait for the glue to dry slightly and try again.
   • Stick, wait and decorate each place one by one. If you want, you can apply adhesive to another place while decorating the old place.

5. 

   Spread the last layer of glue over the trim to fix it. Let dry.

6. 

   Spray a coating of glue to ensure durability and waterproof. Let dry for 15 minutes.

7. 

   Completed! advertisement

What you need

Splicing glass crack:

• UV glue or silicone glue
• Soap
• Country
• Clean towel
• Rubber gloves
• Ultraviolet lamp or sunlight (with UV resin)
• Razor
• Clamps (optional, for holding large glass panels)
• Bui Bui (optional, for cleaning)

Advice

• Guidance Splicing of cracked glass can be done to bond the glass objects together.
• Some silicone adhesives are tubular with a plunger and a nozzle. They can be attached to a "silicon gun" (or pump gun) to better control the amount of adhesive sprayed.

Warning

• Do this in a well-ventilated area if you use glue to release toxic fumes.