Content

• To step
• Part 1 of 3: Pre-treat your engine
• Part 3 of 3: Cleaning and maintaining other parts
• Warnings

You don't wash your bike alone so that it keeps looking good. If you don't wash your bike properly and regularly, you run the risk of it turning ugly and damaging its parts. However, you don't need more than a few simple tools such as water, a sponge and a cleaner to wash your dirty engine. Polish parts like the rims and everything in chrome before you finish the job, and your bike will soon be an eye-catcher again.

To step

Part 1 of 3: Pre-treat your engine

1. Let your engine cool down. It will be a disaster if you spray water on a hot engine block. The sudden change in temperature can cause the engine block to crack. Even if you've only ridden on a wet country road and your bike is full of mud, let it cool before you start.
2. Pack your cleaning supplies. While you wait for your engine to cool down, you can easily grab the things you need to clean it. You can buy all the supplies at a car or motorcycle shop near you. Collect the following:
   • A bucket
   • One or two clean sponges
   • Several clean, dry cloths in chamois or microfibre fabric
   • Degreaser and / or WD-40
   • An old toothbrush to clean small spots
   • Car or motorcycle wash (optional)
   • Insect and tar remover (if necessary)
   • Chrome cleaner (if needed)
3. Polish the seat with a suitable protective agent. The seat of a motorcycle can be made of different materials, but usually it is leather or vinyl. A vinyl seat is quite durable, but the material can fade and crack over time. To overcome these problems, use a suitable vinyl protector. A leather seat is more likely to be damaged, but with a leather maintenance cream you can protect the seat of your motorcycle.
   • You can purchase vinyl and leather protective materials at auto and motorcycle stores.
   • Do not use soap on leather.

Part 3 of 3: Cleaning and maintaining other parts

1. Remove stubborn insect residue. Every motorcyclist knows that after a nice ride, his bike can look like it has been at war with a swarm of flies. If your bike is clogged with insect residue, apply a generous amount of a bug and tar remover. When the dirt has soaked off, wipe it off with a soft sponge or cloth. Then wipe off the last residue with a damp cloth.
2. Clean aluminum rims with soapy water. Many modern motorcycles have lightweight aluminum rims. If you want to clean yours, use only soapy water and a soft cloth. Rinse with water and wipe dry with a dry cloth.
   • Abrasive cleaners and tools can damage the coating and paint on the rims, so do not use them.
   • If you have traditional chrome rims, use a chrome cleaner.
3. Use car or motorcycle wash to better protect your motorcycle. High-quality wax can protect the protective layer of your motorcycle and keep your motorcycle from getting dirty. Apply the wax after thoroughly cleaning your bike. Follow the directions on the spray or wax packaging. The instructions are slightly different for each product.
4. Spray a protective agent on the bearings. The bearings are one of the most important but most delicate parts of an engine. A special protective spray coats the bearings and repels moisture and dirt. Check the packaging of the product of your choice for how to apply it.

Warnings

• Before getting on your bike, test the brakes and lubricate the drive chain to make sure you can ride it safely.
• Do not apply protective sprays to the handlebars, pedals, seat and tire treads. Cleaning products can make these surfaces slippery, making your bike dangerous to ride on.
• Only clean your motorcycle with products that are specifically for cars and / or motorcycles. Cleaners and solvents not intended for cleaning motor vehicles can damage the finish, paint and parts of your motorcycle.