Content

• Steps
• Tips
• Warnings
• What do you need

Are you tired of putting up with this stale smell on your carpets? With this cleaning method, they will look and smell like new.

Steps

1. 1 Dissolve some powder in water. Look, don't go overboard with the quantity. Take a rag and soak it in the resulting solution.
2. 2 Always start by cleaning the vacuum cleaner's dust container. A dirty dust container can leave dirt and dust particles on your carpets. Vacuum the entire floor twice in different directions. This is the best way to capture all the dirt.
3. 3 Dampen a small area on the carpet with a rag, then scoop up the fibers from the surface of the carpet.
4. 4 Prepare the toughest stains by soaking them in the solution for 5 minutes before rubbing them off. Take a carpet brush and scrub the stains in different directions. You can also repeat this process for stubborn stains.
5. 5 Place old white towels and rags on the carpet to keep it from staining and allowing excess water to soak up.
6. 6 After cleaning the entire surface of the carpet, replace the soapy water with fresh clean water.
7. 7 Rinse the cleaned area with water alone, scrub the carpet to remove any soap residue, and then let the carpet dry. It dries faster if you blow on it with a hairdryer or open windows.
8. 8 When the carpet is dry, it will smell like cleaner and look completely clean.
9. 9 Do not stop until you have removed all of the cleaning agent from the carpet, as dirt will adhere very quickly to the cleaning agent residues.
10. 10 When everything is dry, vacuum the floor again. This will fluff up the carpet and will also remove any dirt and dust that will break down with the cleaning agent.
11. 11 Cover the rug with protective sheeting. This will prevent stains from absorbing into the carpet and will make them easier to remove.
12. 12 For spot cleaning of carpet:
    1. Take a clean towel and wipe off the stain
    2. Pour ¼ glass of cold water over the stain
    3. Blot the stain with a clean towel. DO NOT use a towel to wipe the stain, which will make it worse.
    4. Continue blotting the stain and adding water until you wipe everything clean.
    5. Go over the stain again (blot it only) with another clean towel to completely remove any water from the carpet.

Tips

• When cleaning with a steam cleaner, make sure it has a built-in heater core. Thanks to her, the water will be hot! And this is exactly what you need. Hot water will not only help break down dirt, but research has shown that it kills 70% more germs than cold water. Buy a good stain cleaner, deodorant, and carpet strengthening agent. Add it all to your carpet cleaner and brush your carpet line by line. Scrub the carpet until you get the desired result.
• Vacuum your carpet thoroughly before applying moisturizers. Broken "particulate matter" is much easier to remove when dry. Debris left under the carpet can turn into dirt, causing the carpet to crackle, black and permanent stains that are much more difficult to remove.

Warnings

• Take time to clean and dry your carpet without getting in the way without letting others put dirt on it.
• Do not soak the carpet too much, or it will take too long to dry. In addition, water can pass through the carpet and cause the floor to rot.

What do you need

• Water
• Clean towels
• Brush
• Cleaning agent (powder) * * Use only on heavily soiled carpets