Content

• Steps
• Tips
• Warnings
• What do you need

To make the Black 'n Mild cigar weaker, you need to remove the inner, binding sheet, and then the smoke will be softer and more pleasant. Using a few simple techniques, you can remove this sheet quickly, neatly and easily. Read on and find out how.

Steps

1. 1 Cut off the plastic tip of the package over the plastic tip of the cigar. Do not remove the plastic from the cigar. Each Black'n Mild is individually packaged, and you can use this pack to collect the tobacco as you shake it out of the cigar.
   • Since you will need to pour the tobacco back into the cigar at the end, it is best to cut off the polyethylene, not tear it off: you will have a neat, not torn edge, which is convenient to work with.
   • Some people like to cut off the tip of the spatula. Cut it diagonally to create a sharpened edge and make it easier to put the tobacco back in.
2. 2 Make the tobacco inside the cigar less tamped by rolling it gently between your fingers. Basically, you want all the tobacco to spill out of the cigar into the plastic wrap. Feel your Black & Mild with your fingers and make sure the tobacco is free inside.
   • In the process, the tobacco will begin to fall out of the cigar to the bottom of the package. This is good. As you roll, the cigar will begin to come out of the package upward, starting at the tip.
   • Make sure the plastic wrap is flat, without wrinkles or fractures. Make sure that the cigar does not come out of it ahead of time.
3. 3 Draw out the cigar gradually. Continue rolling and shaking out the tobacco into the packaging. Do this slowly and carefully to trap all the tobacco in the plastic. You may need to tamp the tobacco in the plastic a little to make room for leftovers. Continue rolling or tapping it into the package.
   • When you have shaken out most of the tobacco from the cigar, press down on the base of the plastic tip to break up the tobacco underneath. Do not remove the tip, unless you intend to smoke a cigar without it.
4. 4 Remove the cigar completely from the packaging. When you are finished emptying the tobacco from the cigar, you should be left with a plastic wrap filled with it and an empty Black 'n Mild with a filter sheet inside.
5. 5 Roll the cigar to get the inner filter sheet. Take an empty cigar and start rolling it lightly with your fingertips until the filter sheet begins to show up from the inside. Eventually, you will be able to grasp and remove the filter sheet with your fingertips or your fingernails. Throw it out.
   • You can use the inner sheet as a filter without burning it. Cut off about two and a half centimeters and roll it into a very tight ball. Insert it into the cigar before filling the tobacco back. This will prevent tobacco from getting into your mouth when you smoke, and this ball will serve as a kind of filter that you don't have to burn.
6. 6 Gently fill an empty cigar with tobacco. Fall asleep back very slowly. As you do this, regularly tap the plastic tip on a hard surface, or use the bottom of the pen to tamp the tobacco lightly.
   • Be careful not to fill your cigar with too much tobacco.It is difficult to fall asleep back completely, so do not use force to avoid tearing the wrapper leaf. Some people like to leave a little space at the tip and bend the cigar in this place so that the tobacco does not fall out of there when they smoke.
7. 7 Clean the stuck tobacco from the plastic tip. When the cigar is ready, you can, if you wish, remove the tip to remove excess tobacco. Shake it out or blow it out before putting the plastic back on.
   • You can also try blowing the tobacco into the cigar without removing the tip. Sometimes it is quite difficult to put it straight in place, so it is better not to touch it at all, since you are going to use it when smoking.
8. 8 Enjoy. Your cigar is ready.

Tips

• Be careful not to tear / cut the plastic wrap too far or the Black & Mild logo on it.
• When putting the plastic tip back on, do not use too much force to avoid tearing or bending the sheets.
• Use the handle in the middle to push the tobacco into the cigar to avoid tearing or bending the Black & Mild sheets.
• The process can be a little sloppy, so it's best to do this over a bowl of some sort.

Warnings

• Removing the inner filter sheet does not remove nicotine from the cigar or make smoking safer.

What do you need

• Cigar Black & Mild
• Round handle (optional)
• Flat surface (required) or bowl (optional)
• Time and patience